.TIME-SAVER, #E400, Epoxy Resin, 2.8 Litres, price per kit

.TIME-SAVER, #E400, Epoxy Resin, 2.8 Litres, price per kit

  • C$59.00

TIME-SAVER ... suitable for filling small cracks and voids, artwork of very small volume.

Tips of use:
1, Make sure measure by weight, and a small kitchen scale is a must.
2, As volume is very small, use a spoon to take out from bottle. First put 2 part of resin to mixing container, then 1 part of the hardener, totally 3 parts.
3, The resin is thicker than our General Casting. If you use our 
E-PB32 Round Pump Bottle, make sure the resin is NOT cold which make the resin thicker, be very patient and very slowly pumping out (especially for first use, may need more than10 pumping before resin comes out), give enough time to recover after each pumping.

CLICK HERE for Jacquard Pigments & Inks

CLICK HERE for Black Diamond Pigments

Two-component resin system, cure quicker and time saving, formulated for filling small cracks and voids, artwork of small volume.

EYES: Flush with copious amounts of water lifting lids and removing contact lenses to ensure complete irrigation. Get medical attention.
SKIN: Flush with water and then wash with soap and water, launder contaminated clothing before reuse. Get medical attention if irritation persists.

1), Mix 2 parts A with 1 part B by WEIGHT (or 1.8:1 by VOLUME) fully mix.
2), Set to touch in 30 minutes to 4 hours, for volume 2 - 50 ml.
3), Suggested volume of use: 2 - 50 ml, more volume may result overheating, smoke and cracks
4), POT LIFE: 10 Minutes (20 ml at 70 degrees F).

Recommended 55 degrees F. to 85 degrees F., with tightly sealed lids, avoid from direct sunlight.

Shopify secure badge